In order to install and configure your IntesisHome device, please follow instructions listed below in the same provided order:
1. Install IntesisHome device.
Please, follow instructions on the Installation Manual to connect the IntesisHome device to the indoor unit. Remember that installation procedure should be performed by an authorized installer, so contact with your local installer to perform this step.
Result: If installation process has been successful, IntesisHome device LED will be steady GREEN.
If not, please ensure that the air conditioner, heat pump unit or air to water system is connected to mains. If problem still persist, ask you installer to check connections and wiring installation to ensure everything is OK.
2. Configure IntesisHome device.
Before enjoying IntesisHome, you need to configure your IntesisHome device. To do it so, please follow instructions on the Quick Start Guide and the IntesisHome Device Configuration site.
Result: If configuration process has been successful IntesisHome device LED will blink GREEN,YELLOW, RED and finally turns OFF. See image below to check.
If your device is not following this sequence, please check the LED status table below to try to find out which has been the problem.
|Green||Blinking||Checking device configuration parameters (up to 2 minutes)|
|Yellow||Blinking||Downloading configuration. Wait (up to 2 minutes)|
|Red||Blinking||Connecting to access point and server (up to 2 minutes)|
|Red/Green||Alternate Blinking||Error Connecting to Access point or router. Try to connect again and make sure you write the correct password|
|Yellow/Green||Alternate Blinking||Server not reached. Check if there is Internet connectivity on your Access Point or router|
|Blue||Blinking||Performing WPS connection (up to 2 minutes)|
|White||Blinking||IntesisHome device identification|
Remember that before start using the IntesisHome device, you need to register yourself as a user and the device too. See How can I register my IntesisHome device? to get more information.